Setup Item to be Charted in 2D Charting

Follow

When an item number should be charted, but is not setup in D4Web to do so, complete the following actions. The example used in this article is a Temporary Filling, item 572.

  1. Click the navigation menu > Location Setup > Items page 

  2. Select the relevant item to be setup for charting, or add a new item

    1. Applied Area: Select the most appropriate 

      1. Surface: The image/colour will cover the selected surface(s), e.g. Fillings

      2. Tooth: The image/colour will cover the entire tooth, e.g. Crowns

      3. Upper Jaw: The image/colour will apply to only the upper jaw, e.g. Full Dentures

      4. Lower Jaw: The image/colour will apply to only the lower jaw, e.g. Full Dentures

      5. All Teeth: The image/colour will apply to all teeth

      6. Upper Teeth: The image/colour will apply to only the upper teeth, e.g. Partial Dentures

      7. Upper Jaw: The image/colour will apply to only the lower teeth, e.g. Partial Dentures

    2. Teeth Type: Select the most appropriate

      1. Any: The image/colour can be applied to either deciduous or adult teeth

      2. Primary: The image/colour is only chartable on deciduous teeth

      3. Permanent: The image/colour is only chartable on permanent teeth

    3. Record with Tooth's Number:  Tick to automatically record the tooth ID in Treatment Plan

    4. Charting tab
      1. Processing Type: Common (other options are for preset items only)
      2. Image Position: Select where the image should be placed, the options differ depending on the Applied Area selected above
      3. Priority: Low
      4. Item Planned: Either an image or a colour can be selected to represent the item 

        1. Image File: Click to find an appropriate image (optional)

        2. Filling Colour: Select a colour for the surface, also seen as a background when an image is present

      5. Item Done: Either an image or a colour can be selected to represent the item 

        1. Image File: Click to find an appropriate image (optional)

        2. Filling Colour: Select a colour instead of an image, also seen as a background when an image is present

  3. Next, setup: 

    1. Item to be Charted 3DCharting

    2. Operations to use the item in Charting

 

 

0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.